- Low temperature solder sleeve. Material: Polyolefin Tubing with Solder and hot melt adhesive Inside Shrinkage ratio 2:1 . Solder and hot melt adhesive can produce perfect seal, protect electrical connections. Diameter: 2.7 mm, cable cross-section 0.5-1.5 mm²(22-18 gauge).
- High Quality and Durability: Excellent stretch and mechanical damage resistance.
- Easy Operation: No Crimping Required. Simply position the stripped wires into the solder sleeve and apply heat to finish the connection.
- Compliant with All Relevant Standards: Solder seal wire connectors are compliant with ROHS, ISO 9001:2008, SGS and CE standards.
- Repair Work Easier: Heat shrink solder connectors Ideal used for your boat, car, motorcycle, home and any DIY wire connecting project.
Heat Shrink Solder Seal
200pcs Solder Seal Wire Connectors Red 22-18 AWG, Waterproof Heat Shrink Butt Connectors, Automotive Marine Electrical Terminals (Red)
$29.99
+ Free Shipping
The Blacksmith –
I’m rewiring a large Z gauge layout and these are great to replace those darn little Marklin plugs. Easy to use and you get a great permanent connection.
Angel –
I use these quite a bit, this was a refill I needed for a kit I have. I really like how easy they are to use. I’ve used this on tons of automotive applications.
Denise Banks –
Husband purchased and he has no problems with product
NHdave –
I had to bend back my 18ga wire over itself to fill up the opening so the wire held tighter prior to heating. Other than that they worked perfectly using a heat gun to shrink them.
Randal J. Mcmasters –
I had a small sample of these Solder Seals and liked the way they worked so I bought a larger supply here. These are so easy to use. Pull one wire through Solder Seal and then connect to other wire, pull back halfway through Seal to you are in center. Apply heat with heat gun and solder melts onto the wire and the ends also seal, making a secure waterproof connection. I have not had any of these fail. Quick shipper as well
Sal –
I discovered this particular product after having purchased similar products from different companies.Upon receiving the shipment, I immediately put it to the test. I soldered some wire that I did not want to be bulky at the connection point and it came out great. These particular connectors seem thicker than others I’ve purchased before which is a good thing because I’ve had connectors of the same type fall apart shortly after having heated them up.Overall, I’m pleased with the connectors and will order more when I run out!
William A. Cummings –
Overall, these connectors are easy to use and make a clean electrical connection. Slip on, hold in place while using a heat gun – a few seconds to cool and it’s complete. The only negative is the same as using the solder gun – you often need more than two hands to keep everything in place during the heating.
Eric Burgin –
Worked great definitely better than forgetting to put the heatshrink on before soldering the wires together
Kindle Customer –
Like them. Easy to use but much too expensive.?
J.L. Bookthief –
To fabricate a wire harness